Yellow Bullet Forums banner

Reaction score
6

Marketplace Rating
(0.0 - 0 reviews)

Profile posts Latest activity Discussions Buy & Sell Reviews About

  • · Registered
    Joined
    ·
    4,724 Posts
    I used 3 or 5%OD to get 8psi I can't remember so however you get there is up to you on tooth count depending on what belt will fit[1440 belt I think w/61T crank pulley.]I used 8 psi only with Iron heads and ran 10.40 129 mph.

    · Registered
    Joined
    ·
    0 Posts
    Which pistons did you run. I'm getting closer to putting this thing together and am looking at trw low compression forged pistons what do you think?

    · Registered
    Joined
    ·
    0 Posts
    I'm putting together a blown 440. I would like to use the store ck block and steel crank. Can you give me some details about your motor. Did you use stock caps with studs or aftermarket studs? I hope you don"the mind if I pick your brain as I go along thanks

    · Registered
    Joined
    ·
    4,724 Posts
    i have been lazy with my stuff but plan to get out the 8/14/10 at norwalk after the fri chaos.i have been racing with the outlaw dragster crew so not long now.sorry no news!i put in a LC-1 at least so i can omit the intermediat cercuit of the 3 cercuit carb[80532-1 holley 1250's]i will likely go 9.5 /140mph

    · Registered
    Joined
    ·
    4,724 Posts
    showoff!LOL.actualy my friend koolrayz 2002 TA turbo3600lbs only runs 17 lbs and goes 9.0's 155.what is wrong with yours that is is so slow?

    · Registered
    Joined
    ·
    1,805 Posts
    OLDHEAD HERE......ARE YOU RUNNING ? I went back to the track last week,Made 2 run before the rain with one 624 nozzle and went 9.19 & 9.15 at 151.Want to try 2 nozzles.. Then the boost goes from 22 to 27,I think it will go 8.80s.Then the Nitrous..Drove to track (25m)........Good Luck....Oldhead
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top