need opnions on axles, ring, and pinions

[Dom87SS]

i have a 8.5 10 bolt from a g-body, in a g-body. has stock everything but LPW cover. im looking at certing my car to 10.0 and it seems i need aftermarket axles. so while im pullin it apart to do axles, im thinkin i may just do the ring and pinion as well. currently has a stock 3:73 in it and id like to keep that as the car is a little heavy. so obviously we have moser, strange, MW, etc.

what im looking for here is what spline should i be looking to go with as its just a 28 now. who makes a good ring and pinion, axles, posi unit and who is decently priced?


sbc on spray, th400 trans, 28" dr, about 3700lbs

[Scott @ DLS]

If your going to put in c-clip eliminators then go with a spool as well. 4.10 seems to be a good ratio for a 28" tall tire. Also have your tubes welded to the center section for added relyability. Expect a Spool, axles with c-clip elims with studs to be $630.00 and a good gear set is $175.00.

[Cale Aronson]

Check PM's

[Scott @ DLS]

Check PM's


Thank you for using the PM option, some other vendors around here just don't get it!