BS3 Question..

[Monty Mikho]

I was playing around with the software these past few days and reading the manual. Question is.. On the Boost section.. is using PWM setup pretty much like the MSD stuff? Will it use the MAP sensor and try to regulate that pressure? Also can I use the same type of solenoids that MSD unit uses.. Thanks for your time Sparky...:)

[LTLHOMER]

I was playing around with the software these past few days and reading the manual. Question is.. On the Boost section.. is using PWM setup pretty much like the MSD stuff? Will it use the MAP sensor and try to regulate that pressure? Also can I use the same type of solenoids that MSD unit uses.. Thanks for your time Sparky...:)

Either use the staged setup or run one of the AMS-1000's. My understanding is the PWM (pulse-width modulated) is like the factory GN type boost controller setup and is more suited for a street car application. I was going to run the PWM stuff too but got talked out of it.

For a race setup like yours, I'd do the AMS-1000 used in conjuction with a c02 setup to put regulated pressure on top of the gate.

I know I'm not sparky but you helped on my thread so I figured I'd try and return the favor. Good luck either way can't wait to see it go down the track.