Supercharged Mustang Cam

[5LBEATER]

What's up
Just wondering if someone could help me out with getting the right cam for my setup. I have a 306 sbf with stock heads cobra upper and lower and a powerdyne 9pis supercharger. I will be getting new trickflow heads as well as the RPM 2 upper and lower intake. I would like to run anything in the ten's. I have about $3000. to spend? Oh ya i have a 175 shot of NOS to boot.

Thankshttp://upload2.postimage.org/96570/SmallStang.jpg (http://upload2.postimage.org/96570/photo_hosting.html)

[Jay Allen]

I have a 306 sbf with stock heads cobra upper and lower and a powerdyne 9pis supercharger. I will be getting new trickflow heads as well as the RPM 2 upper and lower intake. I would like to run anything in the ten's. I have about $3000. to spend? Oh ya i have a 175 shot of NOS to boot.
306, Decent heads, Supercharger, Good intake manifold, 175 hp of NOS, and you want to run 10's?

TFS-1, TFS-2, F-303, B-303 w/1.7's. Just about any cam will allow you to accomplish your goal.

I would suggest buying a very nice set of heads up front, then get a REAL custom camshaft for the combination and set my goals a let higher.

Good Luck.

[5LBEATER]

Ok sounds good to me what would be the best head that i could get for around $2500.00-$3000.00 ready to bolt on? Than i could always get a custom cam later. the intake that i wanted to go with was the edelbrock RPM 2. I am tryin to keep everything aroung the $3000.00 give or take.

[Jay Allen]

Canfield 192cc 20* heads would be the ticket. I sell them for 1195.00 assembled with very good parts. FULL CNC versions are availble for under 2K with hyd roller stuff.

[5LBEATER]

Ok sounds good to me how much would it cost for that head and a cam to match. If you know what type of increas it would give me that would be cool. I'm hoping to get the car into the 10's.

[5LBEATER]

oh ya i forgot to ask how much do the heads weigh?http://upload2.postimage.org/113712/StreetStang.jpg (http://upload2.postimage.org/113712/photo_hosting.html)

[Jay Allen]

The heads are 1195.00 assembled with good parts and the springs to mact the cam. If you need rocker studs, they are 25 bucks. Then you have freight. How much? I dunno, I ain't a UPS guy! LOL. But I'd bet on about 50.00. The cams start at 369.00 for a steel billet custom ground CNC camshaft. There is none finer. Freight on that is 20 bucks. In a package deal such as this, I do the Cam Dr analysis for free. It takes me about 2 hours to do everything I do. I charge 30.00 for it but in a package, its free.