8 injectors on 1 fuel rail?

[redvictor]

i see it's been done on a few engines....
Rail ID is .560". I beleive it will but i'd like some opinions...

[Monty Mikho]

Red, Im not sure I would go that route.. Weldon recommend 2 of their 2435 pumps on a -12 line for a twin 88 setup.. Now thats a ton of fuel..

[redvictor]

shit,that is a LOT of fuel.....i'm using 2 eliminator pumps with 2 x -8 Y'd into a -10 line that is Y'd at the other end into 2 x -8s to the rails...
bugger,i'm going to struggle to put 2 rails each side.....

[Monty Mikho]

2 rails on each side? You running 2 injectors per runner? Is this on alcohol? If so you may want to look into a mechanical pump..

[redvictor]

no,on pump gas.don't forget it's 572ci and it'll want a lot of fuel. Yes,2 150# injectors per runner. On the calculations for injectors for 2000hp it said 230# of fuel per runner. Maybe it'll only need 1 set but i'm covering the angles...Also don't forget this is a street driver..

[Jim Monson]

I don't think you're going to need 16 injectors. You can raise the base pressure and make the 150lb injectors think they're bigger. I would hate to see you waste money on stuff you don't need.

[redvictor]

LOL....waste money?...i waste money for England and win medals at it.... :-D
Injectors were only $80 each....bargain....

[Jim Monson]

God Save The Queen :-D

[redvictor]

God Save The Queen :-D
it's a facist regime.......... :smt005 :smt005
remember that Jim? i was 17 man..young and stoopid...

[Jim Monson]

:supz: :-Rock :supz:

[redvictor]

thought you might..... :-D