tying into front unibody question

[mike gerlach]

I'm in the process of building a tube 3/4 chassis. I have the sfi info, but a little confused about how to go about tying in the front stock unibody frame rails. (they pretty much end at the firewall) Does anyone have any good pics of the foot bar area along with tying into the front rails? Think Mustangs are similar.

mike
mwgerlach@enter.net

[10.5 outlaw]

Did you get any replies(PM) to your post because I was wondering the same thing?

[mike gerlach]

no I didn't hear anything on this question

[10.5 outlaw]

What are ya building??

[gilsbachracecraft]

mike i lost most of the pics on my computer(bad hard drive)and a friend is trying to extract them.I just started on an outlaw 10.5 fox body this week and i will post some pics w/what you are asking in the next couple of days.

[mike gerlach]

thanks much!

mike

[gilsbachracecraft]

http://www2.propichosting.com/Images/5102206/17.jpg
http://www2.propichosting.com/Images/5102206/18.jpg
http://www2.propichosting.com/Images/5102206/19.jpg