Motor plate

[qwiknotch]

Does anyone make a motorplate for an LS series engine yet?
Perhaps one that goes into a fox body?

[jacobgiles]

jasom glezman does, he is a member of the site.

[LTLHOMER]

I'm selling a set that came in the 00 roller I bought. Could be adapted to work in a msutang perhaps? How wide are your engine bay frame rails?

[qwiknotch]

Not sure, I will measure the frame when I get home and let you know...
thanks :)
I am positive the frame on the camaro is wider, so I could just trim them down.
how much are you looking to get?

I was going to run a class that required motor mounts, but I am switching to drag radial because it will be cheaper to buy a regular k-member without engine mounts and leave me more room for headers. and a built glide is cheaper than a built T400.

[Chris Uratchko]

Jason is a customer of mine.

Fab Jet Services

586-463-9622

[qwiknotch]

Thanks Chris

[GueSS Who ?]

and a built glide is cheaper than a built T400.

Not to sure about that. You can make a TH400 hold up to over 1K rwhp with not alot of work....Mine cost me about 1500 with the ultrabell. My glide cost 4000 with the case and gear set.