Pro Tree Transbrake problem

[charged67camaro]

I have the turbo 350 with a pro tree transbrake. My problem is when i engage the brake for reverse and raise rpm, it stops moving as if i knocked it into neutral. Also the brake does not seem to be working in drive. Whats the problem?

[Hutch]

Have you checked the solenoid, wiring etc?

[charged67camaro]

yes, the wiring is correct. it isnt engaging at all in low gear.

[Hutch]

Sounds like you may have a problem with high gear or the low/reverse clutch which is also used for the transbrake.

Hutch

[charged67camaro]

i got it figure out. the solenoid is not holding the pin in the modulator port in. i have a straight wire going to the battery for 12v. but these solenoid have small wires that the expect you to send alot of voltage through. like i said at first, it hold in reverse until higher rpm. i can manually push the solenoid in and it hold low gear like it suppose to.