Bruno Question

[10.5 outlaw]

I have an small air leak coming out of the exhaust port on my bruno unit when the trans brake is applied. I pulled the front solenoid off and there is a brass shaft a steel collar and a nylon sealing washer all connected with a bolt that slides inside the front solenoid. For those of you that have used a Bruno unit does this sound right or am I missing a piece somewhere? Thanks

[buschmec]

call bruno, you probably dimpled the teflon with some trash, repair parts are fairly cheap.

[Hutch]

You have all the parts. Check the solenoid adjustment by applying 12V to the solenoid and winding it in until it makes contact THEN wind it in an additional 1/4 turn from there after you turn off the power and lock it down. If its in too far or out too far it will leak. If your stuck for a seal there is a farmer method that works great and you can get the seals at any hardware store. You'll need 1 1/4L flat and a 1/4L taper seat faucet washer and your better than that garbage teflon.Loctite in the screw and don't overtighten it or you will distort the seat.

Hutch