PDA

View Full Version : What's the trick setup for a 95Camaro?

MichiganSkip
08-30-2006, 04:01 PM
What's everyone running that works?

Thanks
Skip
MichiganSkip
08-31-2006, 08:33 PM
Suspension wise?
LTLHOMER
09-01-2006, 01:52 AM
Dunno what's trick but I run qa1's with stock springs in rear...and qa1 r's with some hal springs up front. BMR torque arm, billingsley lca's, bmr panhard and that's about it. Good for 1.37's so far and that was the first time we touched the suspension. Went low 1.4's without touching anything.

Hoping to go low 1.3's or high 1.2's once we get it dialed in...that's on 28 inch little et streets btw.
MichiganSkip
09-01-2006, 09:39 AM
Dunno what's trick but I run qa1's with stock springs in rear...and qa1 r's with some hal springs up front. BMR torque arm, billingsley lca's, bmr panhard and that's about it. Good for 1.37's so far and that was the first time we touched the suspension. Went low 1.4's without touching anything.

Hoping to go low 1.3's or high 1.2's once we get it dialed in...that's on 28 inch little et streets btw.
SFC's? 12 bolt right? what gears? Thanks for the reply.
LTLHOMER
09-05-2006, 03:02 PM
SFC's? 12 bolt right? what gears? Thanks for the reply.
BMR tubular weld-in sfc's...moser 12 bolt with 4.10's (need 3.73's) and a spool.